The aim of this study is to establish a general transformation matrix between B-spline surfaces and ANCF surface elements. This study is a further study of the conversion between the ANCF and B-spline surfaces. In this paper, a general transformation matrix between the Bezier surfaces and ANCF surface element is established. This general transformation matrix essentially describes the linear relationship between ANCF and Bezier surfaces. Moreover, the general transformation matrix can help to improve the efficiency of the process to transfer the distorted configuration in the CAA back to the CAD, an urgent requirement in engineering practice. In addition, a special Bezier surface control polygon is given in this study. The Bezier surface described with this control polygon can be converted to an ANCF surface element with fewer d.o.f.. And the converted ANCF surface element with 36 d.o.f. was once addressed by Dufva and Shabana. So the special control polygon can be regarded as the geometric condition in conversion to an ANCF surface element with 36 d.o.f. Based on the fact that a B-spline surface can be seen as a set of Bezier surfaces connected together, the method to establish a general transformation matrix between the ANCF and lower-order B-spline surfaces is given. Specially, the general transformation is not in a recursive form, but in a simplified form.
翻译:暂无翻译